User's Manual
37
6 General Operations
The user in level 2 or 3 has the permission to arm and disarm the system. This section uses end user's
operation on DMSS as an example.
Prerequisites
●
Make sure that you have added a hub before performing configurations.
●
Make sure that the hub has a stable internet connection.
●
Make sure that the hub is disarmed.
Background Information
You can manage alarm hubs and accessories, and perform operations such as arming and disarming,
configuring alarm devices.
Procedure
Step 1 On the hub screen, tap
Accessory
to add the accessories. For details on adding the
accessories, see the user's manual of the corresponding device.
Step 2 Arm and disarm the detectors in a single area or all the areas through manual or scheduled
operations.
●
Single Arming and Disarming: Arm and disarm the detectors in a single area. For details,
see "6.1 Single Arming and Disarming".
●
Global Arming and Disarming: Arm and disarm the detectors in all the areas. For details,
see "6.2 Global Arming and Disarming".
●
Manual Arming and Disarming: Arm the security system through the DMSS app, keypad
or keyfob.
●
Schedule Arming and Disarming: Arm and disarm the detectors by schedule. For
details, see "6.4 Scheduled Arming and Disarming".
6.1 Single Arming and Disarming
You can arm and disarm the detectors in a single area.
Step 1 On the hub screen, tap
Area
.
Step 2 Tap an area, and then select from
Home
,
Away
,
Disarm
, and
Disable
in the pop-up
window.
●
Home
: An arming mode that allows you to arm the system when inside the area of the
alarm system.
●
Away
: Arm the system when you leave the area of the alarm system.
●
Disarm
: Turn the security system off. The opposite of arming.
●
Disable
: Close the current screen.
To Next Page
Loading...
