25
Figure 2-19
2.7.2 Trigger Snapshot
Please follow the steps listed below to enable the activation snapshot function. After you
enabled this function, system can snapshot when the corresponding alarm occurred.
z In main menu, from Setting->Camera->Encode->Snapshot interface, here you can input
snapshot mode as trigger, size, quality and frequency. See Figure 2-20.
z In main menu, from Setting->Event->Detect, please enable snapshot function for specified
channels (Figure 2-21). Or In main menu, from Setting->Event->Alarm (Figure 2-22) please
enable snapshot function for specified channels.
Figure 2-20
To Next Page
Loading...
