Installation and Configuration 10
The VTH configuration is completed.
Configure Main outdoor stations (VTO) and sub outdoor stations (VTO). There
must be only one main outdoor stations (VTO) and one or more sub outdoor
stations (VTO).
If there are no sub outdoor stations (VTO), then you do not need to do sub outdoor
stations (VTO) configurations.
1) Select an outdoor station (VTO).
The VTO Config interface is displayed. See Figure 2-13.
VTO config
2) Select Main or Sub.
Enter local IP, Network, gateway; select video standard, date format, time format;
set date and time.
3) Tap OK.
The Configuration interface is displayed. See Figure 2-14.
To Next Page
Loading...
