Need help?Do you have a question about the Dahua VTO2202F and is the answer not in the manual?
General| Operating System | Embedded Linux |
|---|---|
| Video Compression | H.264 |
| Audio Compression | G.711 |
| Audio Input | Built-in microphone |
| Audio Output | Built-in speaker |
| Ethernet | 10/100Mbps |
| Network Protocol | TCP/IP |
| Tamper Switch | Yes |
| RS485 | Yes |
| Material | Aluminum alloy |
| Camera | 2MP |
| Audio Enhancement | Noise suppression |
| Alarm Output | 1 channel |
| Door Control | 1 channel |
| Power Supply | DC 12V |
| Installation | Wall-mounted |
| Protection Grade | IP65 |
| Operating Temperature | -30°C to +60°C (-22°F to +140°F) |
| Connectivity | Ethernet |
| Display | 7-inch touchscreen |
Lists essential security actions for system protection.
Details environmental and operational conditions for device use.
Specifies requirements for using power supply and electric wires.
Guides through the initial setup and IP address configuration of the VTO.
Explains how to assign a unique number to the VTO for identification.
Details how to set up TCP/IP information for the VTO.
Describes how to configure the SIP server for intercom functionality.
Explains how to set up call numbers and enable group calling features.
Details how to add VTO devices to the SIP server for inter-device calls.
Guides on adding room numbers to the SIP server for VTH connection.
To Next Page