Dahua VTO2202F - VTO Initialization; Configuring VTO Number

Configuration 10
Device initialization Figure 4-1
Enter and confirm the password, and then click Next. Step 3
The Email setting interface is displayed.
Select the Email check box, and then enter your Email address. This Email address Step 4
can be used to reset the password, and it is recommended to finish this setting.
Click Next. The initialization succeeded. Step 5
Click OK. Step 6
The login interface is displayed. See Figure 4-2.
Login interface Figure 4-2
4.3.2 Configuring VTO Number
The VTO number can be used to differentiate each VTO, and it is normally configured
according to unit or building number.
 You can change the number of a VTO when it is not working as SIP server.
 The VTO number can contain 5 numbers at most, and it cannot be the same as any room
number.
Log in the web interface of the VTO, and then the main interface is displayed. See Step 1
Figure 4-3.