Dahua VTO2202F User Manual

Configuration 15
Parameter
Description
Build No.
Available only when other servers work as SIP server.
Unit No.
IP Address
The IP address of the target VTO.
Username
The user name and password for the web interface of the
target VTO.
Password
Click Save. Step 4
4.3.7 Adding Room Number
You can add the planned room number to the SIP server, and then configure the room number
on VTH devices to connect them to the network. This section applies to the condition in which a
VTO device works as SIP server, and if you use other servers as SIP server, see the
corresponding manual for the detailed configuration.
The room number can contain 6 digits of numbers or letters or their combination at most, and it
cannot be the same as any VTO number.
Log in the web interface of the SIP server, and then select Household Setting > Room Step 1
No. Management.
The Room No. Management interface is displayed. See Figure 4-11.
Room No. Management Figure 4-11
Click the Add. See Figure 4-11. Step 2
The Add interface is displayed. See Figure 4-12.

Dahua VTO2202F Specifications

General

Brand	Dahua
Model	VTO2202F
Category	Intercom System
Language	English