Configuration 11
Main interface Figure 4-3
Select Local Setting > Basic. Step 2
The device properties are displayed. See Figure 4-4.
Device properties Figure 4-4
In the VTO No. input box, enter the VTO number you planned for this VTO, and then Step 3
click Confirm to save.
4.3.3 Configuring Network Parameters
Select Network Setting > Basic. Step 1
The TCP/IP information is displayed. See Figure 4-5.
TCP/IP information Figure 4-5
Enter the network parameters you planed, and then click Save. Step 2
To Next Page
Loading...
