Need help?Do you have a question about the Dahua IPC-KW10 and is the answer not in the manual?
General| Scanning System | Progressive |
|---|---|
| IR On/Off Control | Auto/ Manual |
| Lens Type | Fixed |
| Focus Control | Fixed |
| Backlight Compensation | BLC / HLC / DWDR |
| Gain Control | Auto/Manual |
| Noise Reduction | 3D DNR |
| S/N Ratio | More than 50dB |
| Video Compression | H.264 |
| Bit Rate | 32Kbps~8192Kbps |
| Day/Night | ICR |
| White Balance | Auto/Manual |
| Motion Detection | On |
| Region of Interest | On |
| Ethernet | RJ-45 (10/100Base-T) |
| Wi-Fi | Yes |
| Protocol | HTTP, TCP, ARP, RTSP, RTP, UDP, SMTP, FTP, DHCP, DNS, DDNS, PPPOE, IPv4/v6, QoS, UpnP, NTP, Bonjour, 802.1x, Multicast, ICMP, IGMP, SNMP |
| Smart Phone | Android |
| Memory Slot | Micro SD |
All installation and operation should conform to local electrical safety codes. Power source requirements are specified.
Do not apply power before installation completion and follow manufacturer instructions.
Install in a cool, dry place away from sunlight and radiation; ensure proper ventilation and protection from liquids.
Describes how to connect and configure local alarm input/output devices and set up alarm events.
Steps for establishing network connection, including setting IP addresses for PC and camera.
Instructions for accessing the camera's web login page and the main monitoring interface.
To Next Page
