Dahua ITC231-RF1A-IR - 6.3 Configuration Guide

Manual
snapshot
Click on the button to snapshot. Snapshots are saved based on
setup in “Setup->Camera->Video->Path”.
Note:
Check Receive Pictures and then snapshot picture and vehicle info
will be shown in Live interface.
Zoom in
Click on the button to zoom in any area with left mouse. Right click
mouse or click to exit.
Snapshot
Click on the button to snapshot current picture and save it to
storage path.
Record
Click on the button to record When video is open, saved to
“Setting>Storage>Destination>Path.
AUZ Focus
Click it, you can preview AP Peak and AF Max parameters.
The closer the AF Peak value and AF Max are, the better the focus
effect will be. Definition of the two parameters:
 AF Peak: this value is shown during live focus as video feature.
 AF Max: this value is best representation of video clarity.
Chart 6-3
6.2.4 Monitor Window Switch
The monitor window switch interface is shown as in Figure 6-11 Monitor Window Switch.
Figure 6-11 Monitor Window Switch
 ----Display in single window.
 ---- Display in four windows.
 ---- Display in full screen.
6.3 Guide
Quickly set camera work mode, plate pixel check, trigger mode, external light config and etc.