Figure 6-17
Select serial according to actually connected port A and B.
You can select small or big light.
Select to enable detection status of external light.
Select work mode, include：
Turn off：NO light always off
Turn on：NO light always on
Default：According to time or brightness, auto turn on light
Set No light normal work brightness value
Note: valid in auto work mode only
You can auto turn on/off light according to time or brightness.
Time：Set NO light on period. 7 independent days in a week and 6 periods
each day.
Brightness：current brightness is below preset value, light ON; higher than
preset value, light OFF.
Note: valid in auto work mode only
Brightness parameter value
Note：valid in auto work mode and select Brightness only.
Set auto brightness light time.
Note：valid in auto work mode and select Time only.
To Next Page
Loading...