Figure 6-32 Light Group
Click on setup enter light group config interface to set parameter.
Please refer to the following sheet for log parameter information.
Camera height from the ground H
Actual height from camera to the ground
Distance camera & scene bottom L1
Distance from lower border to L pole.
Distance camera & scene middle L2
Distance from middle line to L pole.
Chart 6-15
6.5.1.3.3 Video Analysis-Recognition
By setting recognition, set snapshot of non-plate vehicle, recognition of plate vehicle location.
Select Setting>ITC>Intelligent>Video Analyse>Recognition, see Figure 6-33 Recognition. After
setup is complete, click OK.
Note:
Different models of product and work mode support different recognition contents, please
subject to actual interface.
To Next Page
Loading...