Dahua ITC231-RF1A-IR - Page 56

Step 6. Set OSD option.
Tips:
Click Suggest Overlay to quickly set common overlay format.
Parameter
Note
Insert Front
OSD option to adjust the order selected between.
Insert Back
OSD option to adjust the order selected between.
Modify
All selected OSD information state by turns , you can modify any
OSD options prefix, suffix, and other content, and the number of
separators.
Delete
All selected OSD information state by turns , you can delete any
OSD options.
Remove All
Clear all selected OSD information.
New Line
OSD information will be displayed on the picture branches.
Step 7. Click OK.
6.5.1.5 Snap Cutout
6.5.1.5.1 Snap Cutout
Check the "snap cutout enable" and click "OK", the system will recognize the license plate, the main
driver face, copilot face image cutout a picture stored in the storage path.
Note:
 If you need to master the copilot human face matting, you need to open the corresponding face
overlay feature to take effect.
Figure 6-38 ANPR
6.5.1.6 Extra Device
6.5.1.6.1 Extra Device Status