Figure 6-58 TCP/IP
Please refer to the following sheet for log parameter information.
Set current host name. Max supports 32 characters.
Set Ethernet card to config. Default is wired.
Note: For model with –W, you can use wireless Ehternet card and edit card. You
must reboot device if you have set default card.
Currently it only supports wired.
You can select from static and DHCP mode. In DHCP mode, it automatically
search IP while you cannot set IP/subnet mask/gateway. Plus IP/subnet
mask/gateway display values from DHCP. In static mode, you shall manually set
IP/subnet mask/gateway. To switch from DHCP to static, you must set IP
parameters again.
To Next Page
Loading...