User's Manual
236
Figure 5-196 Email
Step 2 Click to enable the function.
Step 3 Configure the email parameters.
Table 5-59 Email parameters
Enter the address of SMTP server of sender’s email account.
Enter the port of SMTP server. The default value is 25.
Enter the username and password of sender’s email account.
Select the receiver to receive the notification. You can select up to
three receivers.
Enter the email address of mail receivers.
Enter the sender’s email address. You can enter up to three
senders separated by comma.
Enter the email subject.
You can enter Chinese, English and numerals with the length
limited to 64 characters.
Enable the attachment function. When there is an alarm event, the
system can attach snapshots as an attachment to the email.
To Next Page
Loading...
