EasyManua.ls Logo

Dahua N42C3P

Dahua N42C3P
377 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User's Manual
62
Parameter
Description
Type
Local: Connect through RS-485 port.
Remote: Connect through network by adding IP address of PTZ
camera to the Device.
Protocol
Select the protocol for the PTZ camera such as PELCOD.
Address
Enter the address for PTZ camera. The default is 1.
The entered address must be the same with the address configured
on the PTZ camera; otherwise the system cannot control PTZ camera.
Baud rate
Select the baud rate for the PTZ camera. The default is 9600.
Data Bit
The default value is 8.
Stop Bit
The default value is 1.
Parity
The default value is None.
Step 3 Click Apply.
5.6.7.2 PTZ Control
You can use the PTZ control panel to perform the operations such as directing camera in
eight directions, adjusting zoom, focus and iris settings, and quick positioning.
Basic PTZ Control Panel
Right-click the live page, and then select PTZ Control.
Figure 5-33 Basic PTZ control panel
The gray button means system does not support current function.
For some model, the PTZ function is available only in one-window mode.
Table 5-12 PTZ control parameters
Parameter
Description
Speed
Controls the movement speed. The bigger the value, the faster the
movement.

Table of Contents

Related product manuals