Dahua N42C3P User Manual

User's Manual
36
Parameter
Description
Default Ethernet Port
of the two network adapters is disconnected, the system
network status is regarded as offline.
●
Fault Tolerance
: Two network adapters share one IP address. Normally
only one network adapter is working. When this adapter
fails, the other network adapter will start working
automatically to ensure the network connection.
◇
When you test the network status, the network is
regarded as offline only when both network adapters
are disconnected.
◇
The two network adapters are used under the same
LAN.
●
Load Balance
: Two network adapters share one IP address. The two
adapters work at the same time to share the network load
averagely. If one of them fails, the other can continue
working normally.
◇
When testing the network status, the network is
regarded as offline only when both of the two network
adapters are disconnected.
◇
The two network adapters are used under the same
LAN.
The Device with single Ethernet port does not support this
function.
IP Version
Select IPv4 or IPv6. Both versions are supported for access.
DHCP
Enable the system to automatically obtain a dynamic IP
address.
MAC Address
Displays the MAC address of the Device.
IP Address
●
Enter the IP address and then configure the corresponding
subnet mask and default gateway.
●
After configuration, click Test to check whether there is
conflict in IP address.
IP address and default gateway must be on the same network
segment.
Subnet Mask
Default Gateway

Dahua N42C3P Specifications

General

Brand	Dahua
Model	N42C3P
Category	Network Hardware
Language	English