Figure 5-209 Motion Detection
Step 3 Congure the detection region.
1. Click Setting next to Region.
2. Point to the middle top of the page.
3. Select one region, for example, click
.
4. Drag on the screen to select the region that you want to detect.
5. Congure the parameters.
Table 5-56 Detection region parameters
Parameter
Description
Name Enter a name for the region.
Sensitivity
Every region has an individual sensitivity value.
The bigger the value is, the easier to trigger an alarm.
Threshold
Adjust the threshold for motion detection. Every region of every channel
has an individual threshold.
You can congure up to four detection regions. When any one of the four regions
activates motion detection alarm, the channel where this region belongs to will
activate motion detection alarm.
6. Right-click the page to exit.
Step 4 Click Setting next to Schedule to congure the alarm schedule.
Step 5 Congure the anti-dither period.
If multiple alarms occur during the anti-dither period, the system only record the event
once.
Step 6 Congure alarm linkage. For details, see Table 5-50 . This section uses associating siren as
an example.
Enable Alarm Hub, select the alarm hub as needed, and then select siren as needed.
User's Manual
333
To Next Page
Loading...
