Dahua VTH16 Series User Manual

Interface Operation 85
Figure 6-47
Select arm mode.
The system displays password input interface.
Enter arm and disarm password; press [OK].
The device beeps continuously, which represents successful arm. The key displays
corresponding arm mode.
 Default password of arm and disarm is 123456. Please refer to “6.2.6.3 Password
Setting” for details.
 If delay alarm is set in the area, the device will beep continuously at the end of
exit delay time.
6.9.2 Disarm
Please ensure that it is in armed status. Otherwise, disarm will fail.
Press disarm symbol at the lower right corner of the main interface.
The system displays password input interface.
Enter arm and disarm password; press [OK].
The system displays successful disarm.
 Default password of arm and disarm is 123456. Please refer to “6.2.6.3 Password
Setting” for details.
 If you are forced to enter disarm password in case of emergencies, enter
anti-hijacking password, which is the reversed arm password. The system will
disarm, and at the same time, upload alarm info to management center/platform.

Dahua VTH16 Series Specifications

General

Brand	Dahua
Model	VTH16 Series
Category	Intercom System
Language	English