Dahua VTO1220A Quick Start Guide

错误!使用“开始”选项卡将 Heading 1 应用于要在此处显示的文字。 23
Configure the parameters, and be sure to add the SIP server itself too. See Table 5-2.
Table 5-2 Add VTO configuration
Parameter
Description
Rec No.
The VTO number you configured for the target VTO. See
the details in "5.3.2 Configuring VTO Number."
Register
Password
Keep default value.
Build No.
Available only when other servers work as SIP server.
Unit No.
IP Address
The IP address of the target VTO.
Username
The user name and password for the web interface of the
target VTO.
Password
Click Save.
5.3.6 Adding Room Number
You can add the planned room number to the SIP server, and then configure the room number
on VTH devices to connect them to the network. This section applies to the condition in which a
VTO device works as SIP server, and if you use other servers as SIP server, see the
corresponding manual for the detailed configuration.
The room number can contain 6 digits of numbers or letters or their combination at most, and it
cannot be the same as any VTO number.
Log in the web interface of the SIP server, and then select Household Setting > Room
No. Management.
The Room No. Management interface is displayed. See Figure 5-9.
Room No. Management
You can add single room number or do it in batch.
 Adding single room number
7) Click the Add at the mid lower position. See Figure 5-9.

Dahua VTO1220A Specifications

General

Brand	Dahua
Model	VTO1220A
Category	Intercom System
Language	English