Dahua VTO2000A-C Quick Install Guide

9
VTH Monitor Conguration
To congure the VTH unit use the built in menu within the monitor itself, VTH units do not support web browser conguration.
Select Settings and input the engineer password: 002236 (default)
The Product Info menu is used to set the room number of the VTH and to congure the unit as a Master or Extension unit. When
conguring a modular system, each monitor will be congured as a Master.
In the Room No eld input the room number, such as 1 for apartment 1.
Select Settings and then Project Settings, in the project settings menu select NetSet to congure the VTH network settings. When
conguring the network address of the VTH it is vital to ensure the IP address range is within the same Subnet as the VTO.
For both the VTO and VTH to communicate, each unit must have the IP address details of the other unit. To add the VTO unit to the
VTH, select Network and input the VTO units IP address and set Enable Status to ON.
Tel: +44 (0)1457 874 999 | Fax: +44 (0)1457 829 201 | Email: sales@cop-eu.com | Online: www.cop-eu.com

Dahua VTO2000A-C Specifications

General

Brand	Dahua
Model	VTO2000A-C
Category	Measuring Instruments
Language	English