Figure 4- 6
Set VTO
Step 1. Select System Config>Indoor Station Manager, system shows Indoor Station
interface.
Step 2. Click on Add, input VTH Short No., IP Address (optional) to add a VTH. See
Figure 4- 7.
Note:
In Indoor Station interface, you only need to add main VTH, and you do not need to add
extension.
Figure 4- 7
Step 3. In LAN Config interface, check Group Call, and click on OK. See Figure 4- 8.
Step 4. After config is complete, enter Logout interface to reboot VTO.
To Next Page
Loading...
