Click Save.
4.3.7 Adding Room Number
You can add the planned room number to the SIP server, and then configure the room number
on VTH devices to connect them to the network. This section applies to the condition in which a
VTO device works as SIP server, and if you use other servers as SIP server, see the
corresponding manual for the detailed configuration.
The room number can contain 6 digits of numbers or letters or their combination at most, and it
cannot be the same as any VTO number.
Log in the web interface of the SIP server, and then select Household Setting > Room
No. Management.
The Room No. Management interface is displayed. See Figure 4-11.
Room No. Management
Click the Add. See Figure 4-11.
The Add interface is displayed. See Figure 4-12.