Daikin 3MXS68KVM - Page 10

Removal of Electrical Box (Pattern 2) Si121175
8 Removal Procedure
2
Disconnect the
connector for the four
way valve coil [S80].

When reassembling, insert
the clamp into the hole as
below.
3
Disconnect the
connectors for the
thermistors [S90] [S92]
[S93] and the overload
protector [S40].
[S40]: overload protector
[S90]: thermistors
(outdoor temperature,
outdoor heat exchanger,
discharge pipe)
[S92]: gas pipe thermistors
[S93]: liquid pipe thermistors

Pull out the clamp.

When reassembling, insert
each clamp of the
thermistors into one of the
holes as below.

When reassembling, insert
each clamp into the holes.

When reassembling, the
thermistor harness should
be placed between the
electrical box and the reactor
harness as below.
Step
Procedure Points
(R17398)
[S80]
Clamp
(R17397)
[S40]
[S90] [S92] [S93]
(R17399)
[S92]
[S93]
(R17401)
Reactor
harness
Thermistor
ASSY
(R17093)
Reactor harness
Thermistor
ASSY