Daikin AGZ080E - Limited Product Warranty; DAIKIN APPLIED AMERICAS INC. LIMITED PRODUCT WARRANTY (North America); EXCEPTIONS

WarranTy regIsTraTIon form (sCroll)
www.DaikinApplied.com 107 IOM 1206-7 • TRAILBLAZER
™
MODEL AGZ CHILLERS
6/12/15 MLP
Control # - SF99007
4
VI.
MICROTECH SETPOINTS MICROTECH Setting
A. Leaving Evaporator ………………………………………………………………….. °F (°C)
B. Reset Leaving ……………………………………………………………………… °F (°C)
C. Reset Signal
……………………………………………………………………… ma
D. Reset Option ………………………………………………………………………
E. Maximum Chilled Water Reset
………………………………………………….
°F (°C)
F. Return Setpoint …………………………………………………………………….. °F (°C)
G. Maximum Pulldown
……………………………………………………………… °F (°C)
H. Evaporator Full Load Delta T ……………………………………………………… °F (°C)
I. Evap Recirc Timer
………………………………………………………………….
sec.
J. Start-to-Stop Delay ………………………………………………………………….. min.
K. Stop-to-Stop Delay …………………………………………………………………… min.
L. Stage Up Delay ………………………………………………………………………. sec.
M. Stage Down Delay ………………………………………………………………….. sec.
ALARM SETPOINTS MUST BE VERIFIED WITH INSTRUMENTS OF KNOWN ACCURACY
N. Low Pressure Hold ………………………………………………………………. psig (kPa)
O. Low Pressure Unload……………………………………………………………. psig (kPa)
P. Evaporator Water Freeze………………………………………………………… psig (kPa)
Q. High Pressure Cut-Out…………………………………………………………..
psig (kPa)
R. Unit Type =
S. Number of Compressors =
T. Number of Stages =
U. Number of Fan Stages =
V. Software Version =
VII. FOR TGZ Templifier CHILLERS ONLY (Must Be Taken At Full Load)
A. Place Unit in heat recovery mode.
B. Condenser Pressure Drop: psig (kPa) Ft. (kPa)
gpm (lps)
C. Condenser Temperatures:
Inlet
Outlet
D. Head Pressure:
Circuit #1
psig (kPa) Circuit #2: psig (kPa)
E: Evaporator Pressure Drop: psig (kPa) Ft. (kPa)
gpm (lps)
F: Evaporator Temperatures: Inlet
Outlet
G. Suction Pressure:
Circuit #1
psig (kPa) Circuit #2: psig (kPa)
F. Compressor Current Per Phase
Compressor #1 L1 AMPS L2 AMPS L3 AMPS
Compressor #2 L1 AMPS L2 AMPS L3 AMPS
Compressor #3 L1 AMPS L2 AMPS L3 AMPS
Compressor #4 L1 AMPS L2 AMPS L3 AMPS
Compressor #5 L1 AMPS L2 AMPS L3 AMPS
Compressor #6 L1 AMPS L2 AMPS L3 AMPS
VIII. GENERAL
YES NO
A. Are all control lines secure to prevent excess vibration and wear? ……………………………………….
B. Are all gauges shut off, valve caps, and packings tight after startup? ……………………………………
Refrigerant Leaks: