Daikin EWAQ016CAW - Page 33

12 Operation
Installation and operation manual
33
EWAQ016~064CAW + EWYQ016~064CAW
Packaged air-cooled water chiller
4P489435-1B – 2017.10
Result: If is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored, but action 4 is deleted. You
automatically return to step6. Press several times to return
to previous steps in this procedure and finally return to normal
operation.
13 You automatically return to step6; start again to program the
following day.
To program space heating
5 sec
5 sec
INFORMATION
Press to return to previous steps in the programming
procedure without saving modified settings.
1 Press
to enter the programming/consulting mode.
2 Select the operation mode you would like to program using
and .
Result: The actual mode is blinking.
3 Press
to confirm the selected mode.
Result: The actual day is blinking.
4 Select the day you would like to consult or to program using
and .
Result: The selected day is blinking.
5 Press
to confirm the selected day.
6 Hold down
for 5seconds to program the detailed actions.
Result: The first programmed action of the selected day
appears.
7 Select the action number you would like to program or to modify
using
.
8 Set the correct action time using
and .
9 Set the leaving water temperature using
and .
10 Set the room temperature using
and .
11 Press
to select:
▪
: to switch heating and the remote controller off.
▪
: to select automatic temperature calculation for leaving
water temperature
12 Set the appropriate shift value using
and . For
more information about weather dependent setpoint, see
"12.3.6Schedule timer"on page30.
13 Repeat this procedure to program the other actions of the
selected day.
Result: When all actions have been programmed, make sure
that the display shows the highest action number you would like
to save.
14 Press
for 5seconds to store the programmed actions.
Result: If
is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored, but action 4 is deleted. You
automatically return to step6. Press several times to return
to previous steps in this procedure and finally return to normal
operation.
15 You automatically return to step6; start again to program the
following day.
To program quiet mode