Procedure to Remove Electrical Parts Box Si211309E
4 Removal Procedure
3. Procedure to Remove Electrical Parts Box
Procedure Warning Be sure to wait for 10 minutes or more after turning off all power
supplies before disassembling work.
Step
Procedure Points
∗Remove the left and right
side panels, operation display
cover and front grille
according to the procedures
for their removal.
1
Remove the
(1) thermistor,
(2) heater connector
and
(3) rubber clip
connected to the PCB.
2
Remove the 2 screws
fastening the electrical
parts box to the units.
3
Lift the electrical parts
box and remove by
moving toward the right.
Heater connector
Thermistor
Rubber clip
The left and right side panels
have to be taken off in order to
remove the front grille.
Thermistor installation spring
Hook hole
Hooks
To Next Page
Loading...
