Daikin FTE25LV1 - Remove the swing motor

Si041265EC Electrical Box / PCBs / Swing Motor
Removal Procedure 7
5
6
Disconnect the
connector [S26] /
[CN_DSP1] on the
control PCB and
remove the signal
receiver PCB.
Unfasten the 2 hooks at
the bottom and remove
the control PCB.

There are 2 hooks also at
the top of the control PCB.
3. Remove the swing motor.
1 Remove the 2 screws,
and then the swing
motor.
Step Procedure Points
(R23376)
Control PCB
Signal receiver PCB
Hook
[S26] /
[CN_DSP1]
(R21158)
Swing motor
(R2543)