Daikin FTKS35CVMB(9)(8) - Part 7 Removal Procedure

SiENBE04-512A
Removal Procedure 139
Part 7
Removal Procedure
1. Indoor Unit...........................................................................................140
1.1 Removal of Air Filter.............................................................................140
1.2 Removal of Front Grille ........................................................................143
1.3 Removal of Horizontal Blade and Vertical Blade..................................146
1.4 Removal of Switch Box, PC Board and Swing Motor...........................148
1.5 Removal of Heat Exchanger ................................................................154
1.6 Install of Drain Plug ..............................................................................157
1.7 Removal of Fan Rotor and Fan Motor..................................................158
2. Outdoor Unit / ARK(X)S-C ..................................................................162
2.1 Removal of Panels and Fan Motor.......................................................162
2.2 Removal of Electrical Box ....................................................................169
2.3 Removal of Reactor and Partition Plate ...............................................171
2.4 Removal of Sound Blanket...................................................................173
2.5 Removal of Four Way Valve.................................................................175
2.6 Removal of Compressor.......................................................................177
2.7 Removal of PCB...................................................................................179
3. Outdoor Unit / RK(X)H-C, ARK(X)H-C, R(Y)N-C ................................182
3.1 Removal of External Panels.................................................................182
3.2 Removal of Bell Mouth .........................................................................185
3.3 Removal of PCB...................................................................................186
3.4 Removal of Electrical Box ....................................................................194
3.5 Removal of Propeller Fan and Fan Motor ............................................197
3.6 Removal of Compressor Sound Insulation Pad ...................................200
3.7 Removal of Compressor.......................................................................209
3.8 Removal of Four Way Valve.................................................................212
3.9 Removal of Electronic Expansion Valve...............................................215
SiENBE04-512A.book Page 139 Friday, October 5, 2007 1:49 PM