Daikin FTKS35CVMB(9)(8) - To Set the Clock

Instruction SiENBE04-512A
74 System Configuration
NOTE
 To set the clock
1. Press “CLOCK button”.
0:00 is displayed.
blinks.
2. Press “TIMER setting button” to set the
clock to the present time.
Holding down “ ” or “ ” button rapidly
increases or decreases the time display.
3. Press “CLOCK button”.
: blinks.
 Turn the breaker ON
• Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
C
TEMP
ON/OFF
POWERFUL
HOME LEAVE
MODE
TIMER
FA N SWING
SILENT SENSOR
ON CANCEL
OFF
1.3
2
R
 Tips for saving energy
• Be careful not to cool (heat) the room too much.Keeping the temperature setting at a
moderate level helps save energy.
• Cover windows with a blind or a curtain.Blocking sunlight and air from outdoors
increases the cooling (heating) effect.
• Clogged air filters cause inefficient operation and waste energy. Clean them once in about every two weeks.
 Please note
• The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
• If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker OFF.
• Use the air conditioner in the following conditions.
• Operation outside this humidity or temperature range may cause a safety device to disable the system.
Recommended temperature setting
For cooling:26°C – 28°C
For heating:20°C – 24°C
Mode Initial setting Selectable range
COOL Outdoor temperature: 2/3AMK(X)S 10 to 46°C
ARK(X)S –10 to 46°C
ARK(X)H 10 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
• A safety device may work to stop the
operation.(In multi system, it may work to stop
the operation of the out-door unit only.)
• Condensation may occur on the indoor unit and
drip.
HEAT Outdoor temperature: 2/3AMXS –10 to46°C
ARXS –15 to 21°C
ARXH –10 to 21°C
Indoor temperature: 10 to 30°C
• A safety device may work to stop the operation.
DRY Outdoor temperature: 2/3AMK(X)S 10 to 46°C
ARK(X)S –10 to 46°C
ARK(X)H 10 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
• A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and
drip.
SiENBE04-512A.book Page 74 Friday, October 5, 2007 1:49 PM