Daikin FTX50K(M/2)V1B - Field Settings; Temperature Display Switch; When 2 Units Are Installed in 1 Room

Field Settings SiBE041525F
93 Trial Operation and Field Settings
3. Field Settings
3.1 Temperature Display Switch
ARC466A6  You can select Celsius or Fahrenheit for temperature display.
 Press the TEMP
 and ON TIMERbuttons at the same time for 5 seconds to change the unit
of temperature display.
 You can also change the unit of temperature display by pressing the TEMP
 and  buttons
at the same time for 5 seconds.
3.2 When 2 Units are installed in 1 Room
Outline When 2 indoor units are installed in 1 room, 1 of the 2 indoor units and the corresponding
wireless remote controller can be set for different addresses.
Procedure (1) Remove the battery cover of the remote controller and cut the address jumper.
(2) Press the center of the TEMP button and the OFF button on the remote controller at the
same time.
(3) Select A (address setting) with the TEMP or TEMP button.
(4) Press the FAN button to enter the address setting mode.
 The indoor unit operation lamp blinks for 1 minute.
(5) Press the indoor unit ON/OFF button while the operation lamp is blinking.
(6) Press the FAN button on the remote controller for 5 seconds to return to the normal mode.
(R14477)
Address
EXIST
Jumper
CUT
1
2
(R21071)
(1) Jumper
(R21822)
(2)
(4) (6)
(2) (3)
(3)
(R22992)
ON/OFF
(4) Operation lamp
(5) Indoor unit ON/OFF
button