Daikin FTXJ-M - Part 2. Troubleshooting; 2.1. Error codes check; 2.2. Error based troubleshooting; 2.3. Symptom based troubleshooting

ESIE16-02K | Part 2. Troubleshooting 2.1. Error codes check
31/05/21 | Version 1.1 Page 17
RA R32 Split & multi split M-Series
Part 2. Troubleshooting
This part contains the following chapters:
2.1. Error codes check
2.1.1. Error codes via remote controller
2.1.1.1. General
If operation stops due to malfunction, the remote controller’s operation LED blinks, and malfunction code is displayed. (Even if stop
operation is carried out, malfunction contents are displayed when inspection mode is entered.) The malfunction code enables you
to tell what kind of malfunction caused operation to stop.
2.1.1.2. How to clear error codes
1. Replace sensor to new one.
2. Power ON the unit.
3. Clear last error:
- Press “TEMP” and “MODE” buttons at the same time.
Error codes check ................................................................................................................................................................................17
Error based troubleshooting .................................................................................................................................................................20
Symptom based troubleshooting..........................................................................................................................................................44
Component checklist............................................................................................................................................................................49