Daikin FTXP-N9 - Wireless LAN Precautions; Installing the ONECTA App

5 | Operation
User reference guide
26
FTXP20~35N5V1B9 + ATXP20~35N5V1B9
Daikin room air conditioner
4D520466-17M – 2023.08
If operation LED… …and timer LED… …then wireless LAN is…
blinks blinks not connected
is off blinks in 0.5second
interval
running and ready to connect to the
home network via WPS button on
the router.
is off blinks in 1second
interval
▪ connected to the home network
via SSID + KEY.
or
▪ connected to the home network
via WPS button on the router.
4 Press to exit the menu.
Result: The display will return to the default screen.
To connect the wireless LAN to your home network
The wireless adapter can be connected to your home network using the:
▪ WPS button (Wi-Fi Protected Setup) on the router (if present),
▪ The SSID (Service Set Identifier) and the KEY (password) - located on the unit.
To connect using the WPS button
To reset the connection setting to the factory default
Reset the connection setting to the factory default in case you want to:
▪ disconnect the wireless LAN and the communication device (e.g. router) or smart
device,
▪ repeat the setting if the connection was unsuccessful.
1 On home screen menu, hold for at least 5seconds while the unit is not
operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu by pressing twice or repeatedly.
(5 sec.)
2×
3 Hold for at least 2seconds to confirm the selection.
Result: is blinking. The operation and timer LEDs are blinking at the same
time in 1s interval. The setting is reset to the factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.
To turn off the wireless LAN connection
If you want to turn off the wireless connection function:
1 On home screen menu, press for at least 5seconds while the unit is not
operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu by pressing once or repeatedly.