EN
9
OPERATION MANUAL
It is strictly forbidden to reproduce this manual, even partially
FC66003946
Rev 00
Controller for units
FWECSA
ADJUSTMENT MENU
DESCRIPTION DEFAULT
Minimum cooling SET limit 10.0 °C
Maximum cooling SET limit 35.0 °C
Minimum heating SET limit 5.0 °C
Maximum heating SET limit 30.0 °C
Minimum humidity SET limit 35%
Maximum humidity SET limit 75%
Humidity hysteresis 5%
Offset on humidity reading 0%
Minimum value of modulating ventilation 20%
Maximum value of modulating ventilation 100%
Air probe offset 0.0 °C
Water probe offset 0.0 °C
Heating water probe offset 0.0 °C
Economy Hysteresis 2.5 °C
Cooling water consent SET 22.0 °C
Cooling water consent hysteresis 5.0 °C
Heating water consent SET 30.0 °C
Heating water consent hysteresis 7.0 °C
Dehumidification water consent SET 10.0 °C
Dehumidification water consent hysteresis 2.0°C
Valve water consent SET 30 °C
Valve water consent hysteresis 5.0 °C
Heater water consent SET 39.0 °C
Heater water consent hysteresis 2.0 °C
Temperature minimum control SET 9.0 °C
Temperature minimum control hysteresis 1.0 °C
Neutral zone 5.0 °C
Modulating ventilation % in standby 20% 20%
Default values RESET No
SETUP MENU
From the main display, press the UP/DOWN keys to view the
following pages in this order:
• Turning Economy function on
• Enabling electrical heater use
• Turning temperature minimum control on
• Turning humidity control on
• Humidity setpoint
If it is not possible to access editing of one or more entries,
you will need to preventively set the relative configuration
parameters. For example, to enable electric heater operation
you will need to preventively set it up in the configuration
parameters menu.
Some parameters (or possible values) in the
configuration, regulation and setup menus may
not be accessible based on which parameter
setting is selected.
To Next Page
Loading...
Need help?
General
