Maintenance
¡When the surface of the LCD or the main unit of the intelligent Touch Controller is soiled, wipe the soil
off with a piece of cloth soaked in a diluted neutral detergent and wrung sufficiently.
Note
Do not use thinner, organic solvent, strongly acid solution, etc.
The print may fade or wear out and discolor.
Forced rubbing with hard cloth may cause damage to the liquid crystal display unit.
Remove stains, always using a soft waste cloth.
If the unit is stored with water droplets and stains sticking to the liquid crystal display unit, a blot may
be made and the coating may come off.
LCD Maintenance
When Leaving the Product Turned OFF for a Long Time
When you leave the intelligent Touch Controller turned OFF for a long time
(6 months or longer), turn the switch OFF to maintain the battery.
¡The intelligent Touch Controller has a built-in battery for operating the clock in power failure.
The battery mentioned above is for power failure only and it may be completely discharged if no power
is provided for a long time.
The capacity is worth about 2 years of in total if no power is supplied.
¡To use the intelligent Touch Controller again, turn the switch ON.
As shown in the figure, set the battery switch on the left side of this controller to
OFF
(switch knob upper
side) or
ON
(switch knob lower side), using a small blade screwdriver.
Turning this switch OFF does not erase the settings for groups, zones or schedule.
[Setting the switch]
Note
¡Do not touch other switches.
¡Avoid turning the switch ON
and OFF with excessive force;
otherwise such operation may
lead to parts damage and failure.
If electric components in the intelligent Touch Controller are charged with static
electricity, it may cause failure.
Be sure to discharge the static electricity accumulated in your body before
attempting any operation.
To discharge yourself, touch a grounded metal object (control panel, etc.).
R
E
S
E
T
is the location of the knob.
OFF
ON
CAUTION
97
To Next Page
Loading...
Need help?
General
