5-5
5.4 Operation
Follow the procedure shown below to operate the
unit.
Cooling water pipe connections
For water-cooled operation, connect and pass
water through a pipe.
[Note] Use fresh water for the cooling water.
●Connection procedure
1. Connect the inlet joint (①).
2. Connect the outlet joint (②).
●Removal procedure
1. Remove the outlet joint (②).
2. Remove the inlet joint (①).
Connect the cooling water joints as shown below.
Connection procedure:
Insert the ship-side joint into the unit-side joint.
Push them together until you feel them click.
Exercise caution regarding the splashing
of cooling water when connecting and
disconnecting the joints.
Cooling water outlet-side
pipe connection procedure
Installed on the
ship side
A
Removal procedure:
While pressing the female-side joint (A) as
indicated by the arrow in the above figure, pull
the ship-side joint toward you.
(Note) During water-cooled operation,
do not touch the condenser fan
with your hands. (The condenser
fan starts and stops to cooling the
controller box and inverter box.)
②Outlet joint
①Inlet joint
05章LX10F11B3TR16-02En.indd5-505章LX10F11B3TR16-02En.indd5-5 2016/02/029:54:292016/02/029:54:29
To Next Page
Loading...
