Daikin R35DV1 - Page 197

FT15DV2S, FT50/60DSG Si01-501
188 Removal Procedure
5. Removing the control PCB.
1
Undo the two claws on
the lower side, and then
the two claws on the
upper side.
Remove the control
PCB.
2
Control PCB (indoor
unit)
S1: connector for the
fan motor
S21: HA
S26: connector for the
room temperature
thermistor
S32: connector for the
heat exchanger
thermistor
6. Removing the swing motor
for horizontal blades.
1
Remove the screw of
the swing motor.
Step
Procedure Points