Daikin R35DV1 - Page 196

Si01-501 FT15DV2S, FT50/60DSG
Removal Procedure 187
9
Press the receiver units
down and release the
claws on the upper
side, and then undo the
claws on the lower side.

Release the claws on the
upper side.
10
Cut the clamp.
11
The receiver units
contain four PCBs.
Remove each PCB with
releasing claws.
Disconnect every
connector from each
PCB.

Remove the receiver units
while pushing the claws of
connectors.
12
Cut the clamp.

Clamps should be always
available.
Fix it as it was before.
Step
Procedure Points