Si01-501 Instructions
System Configuration 75
5
Indoor Unit
1.
Air filter
2. Air purifying filter with photocatalytic
deodorizing function:
•
These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Display
7. Air outlet
8. Flaps (horizontal blades): (page 13.)
9. Louvers (vertical blades):
• The louvers are inside of the air outlet.
(page 13.)
10. Operation lamp (green)
11. TIMER lamp (yellow): (page 16.)
12. Indoor Unit ON/OFF switch:
•
Push this switch once to start operation.
Push once again to stop it.
•
The operation mode refers to the following
table.
•
This switch is useful when the remote controller
is missing.
13. Room temperature sensor:
It senses the air temperature around the unit.
14. Signal receiver:
•
It receives signals from the remote controller.
•
When the unit receives a signal, you will hear a
short beep.
•
Operation start .............beep-beep
•
Settings changed..........beep
•
Operation stop ..............beeeeep
Mode
Temperature
setting
Air flow rate
COOL
22°C
AUTO
To Next Page
Loading...
