Instructions Si01-501
86 System Configuration
2.3.6 TIMER Operation
16
TIMER Operation
Timer functions are useful for automatically switching the air
conditioner on or off at night or in the morning. You can also
use OFF TIMER and ON TIMER in combination.
To use OFF TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
(page 10.)
1. Press “OFF TIMER button”.
“ ” is displayed.
“” blinks.
2. Press “TIMER Setting button”
until the time setting reaches the
point you like.
• Every pressing of either button increases
or decreases the time setting by 10 min-
utes. Holding down either button changes
the setting rapidly.
3. Press “OFF TIMER button” again.
• The TIMER lamp lights up.
To cancel the OFF TIMER operation
4. Press “TIMER CANCEL button”.
•
The TIMER lamp goes off.
NOTE
•
When TIMER is set, the present time is not displayed.
•
Once you set ON, OFF TIMER, the time setting is kept in the memory. (The memory is canceled when
remote controller batteries are replaced.)
•
When operating the unit via the ON/OFF Timer, the actual length of operation may vary from the time
entered by the user. (Maximum approx. 10 minutes)
•
Reserving the ON TIMER will cause the unit to start running up to one hour before, in order to make
sure the temperature reaches the temperature set on the remote controller by the set time.
NIGHT SET MODE
When the OFF TIMER is set, the air conditioner automatically adjusts the temperature setting (0.5˚C
up in COOL) to prevent excessive cooling for your pleasant sleep.
C
TEMP
ON/OFF
POWERFUL
MODE
TIMER
FAN
SWING
ON
CANCEL
OFF
4
2
1, 3
To Next Page
Loading...
