3 | Specific installer safety instructions
Installer reference guide
18
RZAG71~140N
Sky Air Alpha-series
4P695307-1A – 2024.02
Opening the unit (see
"7.2Opening the units"[
4
34]
)
DANGER: RISK OF BURNING/SCALDING
DANGER: RISK OF ELECTROCUTION
DANGER: RISK OF ELECTROCUTION
Do NOT leave the unit unattended when the service cover is removed.
Mounting the outdoor unit (see
"7.3Mounting the outdoor unit"[
4
35]
)
WARNING
Fixing method of the outdoor unit MUST be in accordance with the instructions from
this manual. See "7.3Mounting the outdoor unit"[435].
Connecting the refrigerant piping (see
"7.4Connecting the refrigerant
piping"[
4
39]
)
WARNING
The field piping method MUST be in accordance with the instructions from this
manual. See "7.4Connecting the refrigerant piping"[439].
NOTICE
▪ Do NOT use mineral oil on flared part.
▪ Do NOT reuse piping from previous installations.
▪ NEVER install a drier to this unit to guarantee its lifetime. The drying material may
dissolve and damage the system.
CAUTION
Install the refrigerant piping or components in a position where they are unlikely to
be exposed to any substance which may corrode components containing refrigerant,
unless the components are constructed of materials that are inherently resistant to
corrosion or are suitably protected against corrosion.
WARNING
Take sufficient precautions in case of refrigerant leakage. If refrigerant gas leaks,
ventilate the area immediately. Possible risks:
▪ Excessive refrigerant concentrations in a closed room can lead to oxygen
deficiency.
▪ Toxic gas might be produced if refrigerant gas comes into contact with fire.
WARNING
ALWAYS recover the refrigerant. Do NOT release them directly into the environment.
Use a vacuum pump to evacuate the installation.
To Next Page
Loading...
Need help?
General
