5 | Operation
User reference guide
18
ATXF50~71A2V1B
Daikin room air conditioner
4P513685-6C – 2019.12
5.4.1 To adjust the airflow rate
1 Press to change the airflow setting as follows:
5.5 Airflow direction
When. Adjust the airflow direction as desired.
What. The system directs the airflow differently, depending on the user selection
(swinging or fixed position). It does so by moving the vertical blades.
Setting Airflow direction
Vertical auto swing
Moves up and down.
[—] Stays in a fixed position.
CAUTION
▪ ALWAYS use a user interface to adjust the angle of the flap. When the flap is
swinging and you move it forcibly by hand, the mechanism will break.
▪ Be careful when adjusting the louvers. Inside the air outlet, a fan is rotating at
high speed.
Note: The movable range of the flap varies according to the operation mode. The
flap will stop at the upper position when the airflow rate is changed to low during
the up and down swing setting.
a Flap range in cooling or drying operation
b Flap range in hating operation
c Flap range in fan only operation
5.5.1 To adjust the airflow direction
1 To use auto swing, press .
Result: will appear on the LCD.
Result: The flap (horizontal blade) will begin to swing.
2 To use fixed position, press when the flap reaches the desired position.
Result: disappears from the LCD.
5.5.2 To adjust the louvers (vertical blades)
1 Hold 1 or both knobs and move the louvers.
To Next Page
Loading...
