EasyManua.ls Logo

Daikin Siesta ATXM20N2V1B - To Remove the Front Panel; About the Air Filters; To Clean the Air Filters

Daikin Siesta ATXM20N2V1B
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7 | Maintenance and service
User reference guide
39
ATXM20~50N2V1B
Daikin room air conditioner
4P518786-2F – 2020.05
7.4 To remove the front panel
1 Hold the front panel by the panel tabs on both sides and open it.
a
a Panel tabs
2 Remove the front panel by sliding it to the left or the right and pulling it
toward you.
Result: The front panel shaft on 1 side will be disconnected.
3 Disconnect the front panel shaft on the other side in the same manner.
a
a Front panel shaft
7.5 About the air filters
Operating the unit with dirty filters means that the filter:
CANNOT deodorize the air,
CANNOT clean the air,
poor heating/cooling,
causes odour.
7.6 To clean the air filters
1 Push the tab at the centre of each air filter, then pull it down.
2 Pull out the air filters.
2
1
Note: (class 50) The titanium apatite deodorizing filter MUST be removed before
cleaning the air filter.
3 Remove the titanium apatite deodorizing filter from all 4 claws.

Table of Contents

Related product manuals