SiBE18-821_C SA Indoor Unit - FFQ, FCQ, FDBQ, FBQ, FHQ Series
Operation Manual 321
13 English
Number of beeps
1 long beep ....... Normal state
Press until the indoor unit beeps twice.
1
2
3
4
Reset of the display
5
6
7
Press the INSPECTION/TEST button
to select the inspection mode “ ”.
“ ” appears on display and blinks. “UNIT”
lights up.
Press PROGRAMMING TIMER
BUTTON and change the unit number.
Press to change the unit number until the
indoor unit beeps and perform the following
operation according to the number of beeps.
3 short beeps .... Perform all steps from
to .
1 short beep ...... Perform and steps.
Press OPERATION MODE SELECTOR
BUTTON
“ ” on the left-hand of the malfunction code
blinks.
Press PROGRAMMING TIMER
BUTTON and change the
malfunction code.
Press OPERATION MODE SELECTOR
BUTTON
“ ” on the right-hand of the malfunction
code blinks.
Press PROGRAMMING TIMER
BUTTON and change the
malfunction code.
Press until the indoor unit makes a long
beep.
The malfunction code is fixed when the
indoor unit makes a long beep.
Press OPERATION MODE SELECTOR
BUTTON to get the display back to the
normal state.
To Next Page
Loading...
Need help?
General
