40
4) Timer Setting
①
After pressing "TIMING", the LCD displays "Week Setting" and "Timer Setting" at the same time.
Then you can press "▲" or "▼" to choose the weekday and press "OK" to save the weekday setting. The LCD
now displays "Timer Setting", and you can continue to set the times of timing.
②
Press "▲" or "▼" to set the number of timed actions for the day (you can set 4, as indicated above Unit No.)
Select a timed action and press OK to select the action (timed ON/OFF).
③
Press "▲" or "▼" to select "Timed On" or "Timed Off" and press "OK". Now the LCD displays "Timer Setting"
and "Time Setting" and the time displayed starts to blink.
④
You can press "▲" to change the hour and "▼" to change the minute" and press "OK" to save the time setting.
Now the LCD displays "Timer Setting" and returns to step
③
. You can continue to set other timed actions for a
whole week and then quit this setting mode.
⑤
To cancel a timed action, set the time for this action to 00:00. To cancel all timed actions, press "MODE" +
"UNIT" until you hear a long beeping sound.
NOTE: TIMED ON/OFF ACTIONS ARE TRIGGERED WHEN THE TIME OF THE WIRE CONTROLLER REACHES THE SET TIME.
THEREFORE, IF THE TIME OF THE WIRE CONTROLLER IS INACCURATE, THE ACTUAL ON/OFF TIME COULD ALSO BE INACCURATE.
IN THE TIMING PROCESS, IF YOU DO NOT PRESS ANY KEY IN FIVE SECONDS AFTER PRESSING THE UNIT, MODE, OR PASSWORD
BUTTON, THE TIMING PROCESS IS TERMINATED AND THE RESULT IS NOT SAVED. THE DEFAULT TIME SETTING IS 00:00.
5) Manual Defrost
When the unit works in heating mode, press "▲" or "▼" until "Manual Defrosting" appears, and then press "OK" to
enter Manual Defrosting mode.
6) Reset
The controller can be reset by sticking the small hole above the "▲" key using a needle-like tool.
To Next Page
Loading...
