Daikin VRV IV Series - To Handle the Compressor Unit; To Remove the Accessories from the Compressor Unit

13 | About the box
Installer and user reference guide
49
RKXYQ5T8+8T7Y1B + RDXYQ5T8+8T7V1B
VRV IV heat pump for indoor installation
4P499898-1B – 2021.12
13.2.2 To handle the compressor unit
▪ With packing. Use a forklift.
▪ Without packing. Carry the unit slowly as shown:
13.2.3 To remove the accessories from the compressor unit
1 Remove the accessories (part 1).
a
1×
b
1×
c
1×
d
1×
e
1×
f
3×
a General safety precautions
b Compressor unit installation and operation manual
c Fluorinated greenhouse gases label
d Multilingual fluorinated greenhouse gases label
e Screw (only needed in case 5HP for shield of transmission wiring) (see "17.2To
connect the electrical wiring on the compressor unit"[493])
f Cable tie
2 Remove the service cover. See "15.2.2To open the compressor unit"[463].
3 Remove the accessories (part 2).
1×1× 1× 1×1×
8 HP
a eb dc
1× 1×1×1×
d cba5 HP
a+b Piping accessories for circuit 1 (to the heat exchanger unit)
5HP 8HP
a Liquid Ø12.7mm Ø12.7mm
b Gas Ø19.1mm Ø22.2mm