HXHD125A7V1B
VRVIII system indoor unit
4PW62585-1 – 11.2010
Operation manual
16
Programming quiet mode
Programming quiet mode is carried out as follows:
1 Press the < button to enter the programming/consulting mode.
2 Select the operation mode you would like to program by means
of the pi and pj buttons.
The actual mode is blinking.
3 Press the < button to confirm the selected mode.
4 Consult the actions by means of the pi and pj buttons.
5 Hold down the < button for 5 seconds to the program the
detailed actions
The first programmed action appears.
6 Use the < button to select the action number you would like to
program or to modify.
7 Use the pi and pj buttons to set the correct action time.
8 Use the ba button to select or deselect x as action.
9 Repeat steps 6 to 8 to program the other actions of the selected
mode.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
10 Press the < button for 5 seconds to store the programmed
actions.
If the < button is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored but 4 is deleted.
By pressing the pr button several times, you return to previous
steps in this procedure and finally return to normal operation.
11 You automatically return to step 5, start again to program the
following day.
INFORMATION
Returning to previous steps in the programming procedure
without saving modified settings is done by pressing the
pr button.
To Next Page
Loading...
