EasyManua.ls Logo

Daitsu DOS-9UM - Manual Operation; Operating Temperature

Daitsu DOS-9UM
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH
71
OPERATING TEMPERATURE
Cooling operation Heating operation Drying operation
Room temperature 17ºC ~ 32ºC 0ºC ~ 30ºC 17ºC ~ 32ºC
18ºC 43ºC
Outdoor temperature ( -5ºC ~ 43ºC:For the models with -7ºC ~ 24ºC 11ºC ~ 43ºC
low temperature cooling system)
Mode
Temperature
1- Open and lift the front panel up to an angle until it remains
fixed with a clicking sound.
2- Push the button until the AUTO indicator is lit, the unit will
work in forced AUTO mode (the default setting temperatu-
re is 24ºC).
3- Close the panel firmly to its original position.
1- Open and lift the front panel up to an angle until it remains
fixed with a clicking sound.
2- Push the AUTO button and the air conditioner will run in
AUTO mode.
3- Close the panel firmly to its original position.
Note: The "COOL" mode on the control board is only provi-
ded for testing purposes.
Manul operation can be used temporarily in case you can not find the remote controller or its batteries are exhausted.
MANUAL OPERATION
Manual
control button
AUTO/COOL
Manual
control button
AUTO/COOL
Manual
control button
AUTO
COOL
Manual
control button
(For < 16000Btu/h Models)
(For 16000 ~ 21000Btu/h Models)
AUTO
COOL
Once you push the manual button, the operation mode
is shifted in an order as: AUTO, COOL, OFF.
Push the manual button until the OPERATION indicator
flashes rapidly (five times per second), the unit now is
operating in forced COOL mode. This is used for testing
purposes only, .
When the OPERATION indicator goes off, the air condi-
tioner is OFF.
To restore the remote controller operation, use the
remote controller directly.
CAUTION
1- If air conditioner is used outside of the above conditions, certain safety protection features may come into operation and
cause the unit to function abnormally.
2- Room relative humidity less than 80%. If the air conditioner operates in excess of this figure, the surface of the air conditio-
ner may attract condensation. Please sets the vertical air flow louver to its maximum angle (vertically to the floor), and set
HIGH fan mode.
3- Optimum performance will be achieved within these operating temperature.
CAUTION
06Manual 18Daitsu ENG 18/12/06 12:36 Página 71

Table of Contents

Related product manuals