EN
Page | 54
Power levels (L levels) of the energy controllers
Switching on the hob
The heating zones are regulated by energy controllers located on
the control panel of the built-in appliance, which allow changing the
regulation of heat retention (about 7% of heating capacity) up to
the maximum temperature.
Next to the energy controller or cycle switch there is a hob diagram
showing the position of the relevant hob. A light indicator shows
when the hob exceeds a temperature of 50° C (residual heat
indicator) and only goes out when the temperature falls below this
temperature again.
Switching off the glass ceramic hob
Turn the energy controller to "0".
To Next Page
Loading...
