46
Installation
The machine shall be placed on
a surface guaranteeing secure
support.
When arranging the systems, a
hole (10 x 10 cm
A
Pic. 1 shall be
made in the support surface to
allow the connections with the
systems in the under counter
space
B
Pic. 1.
The machine must be connec-
ted exclusively to an appropria-
te cold drinking water source, in
compliance with national norms
and rules.
The pressure of the incoming
water must be between 0.1 and
0.6 MPa. If this requirement is
not met, consult the manufac-
turer.
A shut-off tap must be installed
between machine water hose and
water system to block water flow
in case of necessity (
1
Pic. 1).
Connect the drain siphon
5
Pic. 1
with a minimum diameter of 40
mm to the drain system of the
place of installation.
The machine has no plug since
it requires a direct connection to
the electrical network. It is thus
necessary to install an omnipo-
lar switch compliant with norms
and rules (
7
Pic. 1).
To Next Page
Loading...
