Danbit H.264 DVR - Page 47

47
Send E-mail / Upload
to FTP with Pre-/
Post-alarm
Recording
(*p[1])
Condition 1:
Network Setup >>Mail(/FTP) Setup >>Tick "Motion(/Alarm)"; And
Record Setup >>"Record Mode" set to "Manual"; And it's on recording
when alarm is triggered
Condition 2:
Network Setup >>Mail(/FTP) Setup >>Tick "Motion(/Alarm)"; And
Record Setup >>"Record Mode" set to "Alarm Trigger"
Condition 3:
Record Setup >>"Record Mode" set to "Schedule"; And Record Setup
>>Schedule Setup >>It's on "Full Rec" or "Alarm Rec" period when
alarm is triggered; And Record Setup >>Mail(/FTP) Schedule Setup
>>It's on "Motion/(Alarm) Mail(/FTP)" period when alarm is triggered
※It's enabled when both necessary nondition and one of above three
conditions are met.
*p: Mail/FTP server setting: Network Setup>>Mail(/FTP) Setup>>Fill
in server information
*p: Pre-/ Post-alarm recording length setting: Record
Setup>>Pre(/Post)-Alarm Record Time
X
Http CGI
Network Setup>>HTTP Notification Setup>>Fill in Http server information and tick
"Enable"
*p[1]: Another interpretation:
Send E-mail / Upload
to FTP with Pre-/
Post-alarm
Recording
Condition 1:
Record Setup >>"Record Mode" set to "Manual" or "Alarm Trigger".
It's not on "Stop Rec" period; And Network Setup >>Mail(/FTP) Setup
>>Tick "Motion(/Alarm)"
Condition 2:
Record Setup >>"Record Mode" set to "Schedule". It's not on "No
Rec" period; And Mail(/FTP) Schedule Setup >> It's not on "No
Mail(/FTP)" period
※It's enabled when both Necessary Condition and one of above two
conditions are met.